Filter
Top Products
Page 22
Page 23
Balanced Connections
If your preamplier has balanced XLR outputs, it can be connected to the amplier inputs as shown.
The amplier will boost the preamplier’s output, up to a level suitable for driving speakers. The
overwhelming advantage of using the balanced XLR inputs is that there is superior noise rejection
over the common RCA type connections.
Make sure that the positive speaker wires do not touch the negative speaker wires, or any chassis
metal. This will cause a short circuit and may activate the protection circuitry. The 12 VDC trigger
connection shown can be used to turn the amplier on when the preamplier turns on. This is the
preferred method of activating the MPS-1. Alternatively, you could use the amplier’s SIGNAL switch
position. The amplier will then automatically turn on when a preamp audio signal is received.