Filter
Top Products
ENGLISH
OPERATION
PROCEDURE
79
4 OPERATION PROCEDURE
Presentation using printed materials
When connecting this product and the peripheral units, be sure to turn OFF the power supply to all units
beforehand.
q Setting the main unit
Set the main unit as show in the above figure, connect the main unit to the projector or the
PC monitor, and then turn ON the power supply.
w Adjusting the lamp position
While watching the screen, adjust the angles of the lamp column and the lamp head until
the illumination is provided uniformly over the stage. Bring the lamp column closer to the
camera head as much as possible but only to such an extent that the lamp head is not
seen on the screen, and then face the light emitting part of the lamp head right
downward, and the illumination will flood over the stage evenly.
Depending on the lamp position, the camera column shadow may be seen on the screen.
e Adjusting the size
Place an object on the stage, and adjust the position of the object with the zoom dial
[ZOOM] on the front operating panel or the zoom button ([], []) on the wireless
remote control so that the part of the object to be viewed can fit the screen size.
r Adjusting the focus
Press the [AF] button on the front operating panel or wireless remote control to focus the
camera on the object.
t Adjusting the brightness
Press the [IRIS
·
OPEN] button and [IRIS
·
CLOSE] button on the front operating panel
or wireless remote control to adjust the brightness of the image by the lens iris.
P.91
P.86
P.87
P.93