32
Select the desired video input source to
enter its label.
1
Press the VIDEO LABEL button to enter
the video label mode.
Example) When selecting VIDEO 1.
2
Select the character on the flickering digit.
3
Confirm your selection.
4
Repeat the above steps and to enter
the desired characters on the rest of the
digits.
5
Memorize the desired video label.
6
Entering a video label
Select the desired video input source to be
rectified or cleared.
1
Repeat the steps ~ in “Entering a
video label” procedure.
2
Correcting or clearing a video label
• Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols: ( ) + , . /
• This function can be operated only on video input
sources such as VIDEO 1~4.
• Then the next digit will flicker.
• On up to 9 digits, the desired characters can be
entered.
Note: If any button such as “AUDIO”, “VIDEO”,
“7.1 CH DIRECT” button, etc. is pressed
while entering a video label, the video label
mode will be canceled.
• To clear a video label, make a blank on each digit
and memorize it, then the video label is cleared and
its factory video input source will be displayed.
• If the VIDEO LABEL button is pressed for more
than 3 seconds, blanks will be made on all the digits
at once.
