DTS RV4700 DTS-ES Stereo Receiver User Manual


 
16
Operate the selected component for
playback.
5
Select the tone mode as desired.
7
Select the digital or the analog input
connected as desired.
4
󳂮At the tone defeat mode, each time the MULTI
CONTROL knob is rotated, the tone defeat mode
changes as follows:
DEFEAT ON : When listening to a program source
without the tone effect.
DEFEAT OFF : When adjusting the tone for your taste.
󳂮At the desired tone (bass or treble), each time the
MULTI CONTROL knob is rotated, the tone level
can be adjusted within the range of +10~ -10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0(flat) level.
• To complete tone adjustment, repeat the above steps
and .
• Extreme settings at high volume may damage your
speakers.
• Each time this button is pressed, the tone mode
changes as follows:
󳂵 BASS 󳂵 TREBLE 󳂵 DEFEAT OFF(or ON)
• The tone display is shown for 5 seconds.
• If the tone display disappears, press the TONE
MODE button again.
• ( ) : When the tone defeat function is activated
(“DEFEAT ON”), bass and treble modes cannot be
selected
󳂮Note:
• When the source direct function is activated, the
tone mode cannot be selected.
• When playing back the program sources with
surround sound, refer to “ENJOYING SURROUND
SOUND” on page 21.
Adjust the (overall) volume.
6
At the desired tone mode, adjust as
desired.
8
When CD, TAPE MON or VIDEO 1~ VIDEO 4
is selected
Adjusting the tone (bass and treble)
• Each time this button is pressed, the corresponding
input is selected as follows:
󳂵 DIGITAL 󳂵 ANALOG
• To listen to DTS, Dolby Digital or MPEG program
sources in the 2-CH downmix mode, in the stereo
mode, the digital input should be selected. (For
details, refer to “Downmixing into 2 front channels”
on page 24.)
• When TUNER or AUX is selected as an input source,
the analog input is automatically selected.
󳂮Notes:
• When the selected digital input is not connected.
“DIGITAL” is flickering, meaning no sound. (Refer
to “ENJOYING SURROUND SOUND” on page 21.)
• To select the digital input, you should match the
connected DIGITAL IN to the corresponding input
source.
(For details, refer to “When selecting the DIGITAL
IN SETUP” on page 39.)
DIGITAL/ANALOG
TONE MODE
MULTI CONTROL
DVD
VOL.
CH LEVEL
OSD
CH SEL
DSP
MODE
AUTO
ST
CENTER
MODE
TEST
TONE
DISC
P.SCAN
TUNER
CD
T1/MONAUX
PHONO
VID1 VID2 VID3 VID4VID5
SYS DISPSLEEP
DIRECT IN
ROOM2
INTRO
RETURN
B
RPT
A
7.1 SURR
TITLE
ENTER
HOME THEATER MASTER
RV4700 DTS-ES
MASTER VOLUME
DOWN
UP
or
VOL.