Filter
Top Products
12
LOADING BATTERIES
OPERATING COMPONENTS WITH REMOTE CONTROL
1 2
• When a button is pressed, the corresponding
DEVICE button flickers.
• However, in case of DVD player, aim it at the
REMOTE SENSOR on the corresponding
component.
DVD
VOL.
CH LEVEL
OSD
CH SEL
INTRO
RETURN
DSP
MODE
AUTO
ST
CENTER
MODE
TEST
TONE
DISC
P.SCAN
TUNER
CD
T1/MONAUX
PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISPSLEEP
DIRECT IN
ROOM2
RPT
AB
7.1 SURR
TITLE
ENTER
HOME THEATER MASTER
RV4700 DTS-ES
7m
30
30
REMOTE CONTROL OPERATION RANGE
• Use the remote control within a range of about 7
meters (23 feet) and angles of up to 30 degrees
aiming at the remote sensor.
Remove the cover.
Load four batteries(“AAA” size, 1.5 V)
matching the polarity.
• When this remote control does not operate the component, the old batteries should be replaced.
• If the batteries are removed for a longer period of time, the remote control might lose its memory and require reentering.
Enter the setup code of the components
respectively, referring to “ENTERING A
SETUP CODE”(page14).
Turn on the components you want to
operate.
1
Press the DEVICE button on the remote
control corresponding to the component
you want to operate.
2
Press the button corresponding to the
operation you want while aiming the
remote control at the REMOTE SENSOR
on the component.
3
4