Filter
Top Products
14
ENTERING A SETUP CODE
• This remote control can control up to eight different components.
• Before operating audio and video components using the remote control supplied with this receiver, the setup code for each
component should be entered.
DVD
VOL.
CH LEVEL
OSD
CH SEL
DSP
MODE
AUTO
ST
CENTER
MODE
TEST
TONE
DISC
P.SCAN
TUNER
CD
T1/MONAUX
PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISPSLEEP
DIRECT IN
ROOM2
INTRO
RETURN
B
RPT
A
7.1 SURR
TITLE
ENTER
HOME THEATER MASTER
RV4700 DTS-ES
For receiver or amplifier :
For CD player :
For CABLE :
DVD
VOL.
CH LEVEL
OSD
CH SEL
DSP
MODE
AUTO
ST
CENTER
MODE
TEST
TONE
DISC
P.SCAN
TUNER
CD
T1/MONAUX
PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISPSLEEP
DIRECT IN
ROOM2
INTRO
RETURN
B
RPT
A
7.1 SURR
TITLE
ENTER
HOME THEATER MASTER
RV4700 DTS-ES
For receiver or amplifier :
For CD player :
For CABLE :
Repeat the above steps to for each
of your other components.
7
Operate the component using the
corresponding function buttons on the
remote control such as POWER, CH /
and VOL / buttons, etc.
6
Example) The correct setup code for this receiver is
“001”.
• If any of the buttons do not perform as they should start
from step again to enter the next setup code.
Notes:
• Some audio and video components have separate buttons
for POWER ON/OFF.
In this case, press the corresponding DEVICE button to
turn the component ON and press the POWER button to
turn the component OFF.
• If there is no correct setup code or if the
Manufacturer/Brand for your component is not listed in
“Set-Up Code Table” in the operating manual of this
remote control, please use the “Auto Search Method” on
page 10 in the operating manual of this remote control.
• Although each setup code is designed to work with many
different modes, certain codes may not work with some
models. (Also, certain codes may only operate some of
the functions available on a given model.)
Find the setup code for your component
referring to “Set-Up Code Table” in the
operating manual of this remote control.
2
Turn on the component you want to control.
1
Example) When entering the setup code for this
receiver, turn on this receiver.
DVD
VOL.
CH LEVEL
OSD
CH SEL
DSP
MODE
AUTO
ST
CENTER
MODE
TEST
TONE
DISC
P.SCAN
TUNER
CD
T1/MONAUX
PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISPSLEEP
DIRECT IN
ROOM2
INTRO
RETURN
B
RPT
A
7.1 SURR
TITLE
ENTER
HOME THEATER MASTER
RV4700 DTS-ES
001
102
For "001" :
For "102" :
Enter the 3 digit setup code aiming the
remote control at the REMOTE SENSOR
on the component.
4
Press the corresponding DEVICE and the
MUTE buttons simultaneously.
3
• Your component will be turned off when the correct
setup code is entered.
• Continue to enter the corresponding codes until your
component turns off.
• If the LED lamp and the corresponding DEVICE
button go off, start from the step again.
• Then the LED lamp and the corresponding DEVICE
button on the remote control light up for 20 seconds.
• Then the LED lamp and the corresponding DEVICE
button will flicker twice.
5
Press the corresponding DEVICE button to
store the setup code.