26
Repeat the above steps to to
memorize other stations.
4
After selecting the tuner as input source,
select the preset tuning mode.
1
• When using the NUMERIC buttons on the remote
control.
Examples) For “3” :
For “15” :
For “30” :
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station is
stored automatically without pressing the MEMORY/
ENTER button.
• A stored frequency is erased from the memory by
storing another frequency in its place.
• If “MEMO” goes off, start again from the above step .
• Then “PRESET” lights up.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned
off, are memorized.
• INPUT SELECTOR settings
• Surround mode settings
• Preset stations, etc.
Note : If the electricity fails or the AC input cord is
disconnected for about 2 weeks, they are all
cleared. So you should memorize them again.
• When using the NUMERIC buttons on the remote
control.
Examples) For “3” :
For “15” :
For “30” :
• When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will be
tuned to automatically without selecting the preset
tuning mode.
Tuning to preset stations
• The receiver will start scanning the stations in the
preset sequence and each station is received for 5
seconds.
• At the desired station, press this button again to
stop scanning.
Scanning preset stations in sequence
Select the desired preset number.
2
Select the desired preset number(1~30)
and press the MEMORY/ENTER button.
3
