Filter
Top Products
Getting Started Getting Started
3
ENGLISH
ENGLISH
Cautions on loading discs
•Only load one disc at a time. Loading two or more discs can damage
the set or scratch the discs.
•Do not use cracked or warped discs or discs that have been repaired
with adhesive, etc.
•Do not use discs on which the sticky part of cellophane tape or
labels is exposed or on which there are traces of where labels have
been removed. Such discs could get caught inside the player and
damage it.
About discs
Discs usable on this set
q
Music CDs
Discs with the mark at the right can be used on
this set.
Note however that discs with special shapes
(heart-shaped discs, octagonal discs, etc.) cannot
be played. Do not attempt to play them, as doing
so could damage the set.
w
CD-R/CD-RW
•Some discs and some recording formats may not be playable.
•Non-finalized discs cannot be played.
Finalization:
Finalization is the process that makes recorded CD-R/CD-RW discs
playable on compatible players.
Holding discs
Do not touch the signal surface.
Loading discs
•Set the disc with the labeled side facing up.
•Make sure the disc tray is fully open when inserting the disc.
•Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1),
8 cm discs in the inner tray guide (Figure 2).
Figure 1
Outer tray guide
12 cm discs
Figure 2
Inner tray guide
8 cm discs
•Place 8 cm discs in the inner tray guide without using an adapter.
•In the following cases, “00 Tr 00 : 00” is shown on the display:
•When no disc is loaded
•When the disc is loaded upside-down
•When the disc’s information could not be read properly
Speaker system (SC-S81)
When installing the speakers, pay attention to the points described
below.
•Note that placing the speaker system on the same stand or shelf as
a record player may result in howling.
•If a magnet or a piece of furniture or equipment using magnets is
placed near the speakers, note that interaction with the S-81 could
cause color blotching on the TV.
•The speakers can also be placed sideways.
Set the speaker sideways and fasten the stand securely to the
speaker using the two screws that previously fastened the stand.
Grasp the two edges of the saran net with your fingers and pull
towards you to remove the net, then press on the back of the badge
and turn the badge to set it sideways.
•The speakers can also be installed using the included wall
mount brackets.
Use the four included short screws to securely fasten the wall
mount bracket to the mount screw holes on the back of the speaker.
SC-S81
SC-S81
Screws
Screws
Speaker stand
Wall bracket
CAUTION:
•Mount on a wall sufficiently sturdy to bear the weight of the
speaker. Note that DENON will except no responsibility
whatsoever for damages or accidents caused by the speaker
falling.
•To ensure safety, have a specialist install the speakers on the
wall.
•Be sure to fasten the speaker connection cables to the wall, etc.,
so that you do not get your feet or hands caught in them, causing
the set to fall.