Filter
Top Products
ENGLISH
33
4
Press the ENTER button to display the
menu’s setting screen.
On the setting screen, the selected
item is displayed in yellow and the
values of the other items are
displayed in green.
ENTER
Remote control unit
[1] TV screen size setting
QUICK SETUP MENU
SELECT YOUR TV SYSTEM
4 : 3 PAN & SCAN
4 : 3 LETTER BOX
16 : 9 WIDE
4 : 3 TELEVISION
SELECT THIS TO PLAY WIDE DVDs
IN THE PAN & SCAN MODE.
(WITH THE SIDES OF THE PICTURE
CUT OFF)
DECISION : ENTER BUTTON
SELECT :
DENON
• The currently set value is displayed in yellow.
5
Use the
• and
ª cursor buttons to
select the desired TV screen size and
display type.
The selected TV screen size is
displayed in yellow and the
description is displayed in green.
Remote control unit
DENON
QUICK SETUP MENU
SELECT YOUR TV SYSTEM
4 : 3 PAN & SCAN
4 : 3 LETTER BOX
16 : 9 WIDE TELEVISION
SELECT :
DECISION : ENTER BUTTON
SELECT THIS TO PLAY WIDE DVDs
IN THE FULL-SCREEN MODE.
16 : 9 WIDE
DENON
6
Press the ENTER button to set the
selected setting.
• The screen shown below appears.
ENTER
Remote control unit
[2] Speaker system settings
DENON
DECISION : ENTER BUTTON
QUICK SETUP MENU
SELECT TOUR SPEAKER SYSTEM
EXIT
2CH VIRTUAL
SELECT :
FRONT
SUBWOOFER
2CH VIRTUAL&SW
SMALL
YES
•“Return” is displayed in yellow.
• The currently set value is displayed in green.
• If you do not want to change the setting, press the ENTER
button at “Return”. The screen in step 2 reappears.
• To change the setting, proceed to step 7 below.
7
Use the
• and
ª cursor buttons to
select the speaker system to be used.
Remote control unit
8
Press the ENTER button to set the
selected setting.
• The setup screen in step 2 reappears.
/
The setup mode is quit in step 9.
The setup mode can also be quit by
using the
• and
ª cursor buttons at
the setup screen to select “EXIT
SETUP” then pressing the ENTER
button.
ENTER
Remote control unit
9
Press the SETUP button to quit the
setup mode.
The setup mode can also be quit by
using use the
• and
ª cursor buttons
at the setup screen to select “EXIT
SETUP” then pressing the ENTER
button.
SETUP
Remote control unit
About the speaker system settings
B 2CH VIRTUAL
Select this when only using with the two speakers for the front
channels.
B 2CH VIRTUAL & SW
Select this when using two speakers for the front channels and
a subwoofer with built-in amplifier.
• Settings
Front : Small
Subwoofer : Yes
Subwoofer frequency : 150 Hz
Set the front speakers and subwoofer at equal distances.
NOTE:
• The speaker system is set to “2CH VIRTUAL & SW” upon
shipment from the factory. It is not possible to achieve the
normal bass sound using this setting but with only speakers for
the two front channels. If only using speakers for the two front
channels, change the setting to “2CH VIRTUAL”.