Filter
Top Products
108
ENGLISH
24
SPECIFICATIONS
2 Audio Section
• Power Amplifier Section
Rated output: Front: 20 W + 20 W (8 Ω/ohm load, 20 Hz to 20 kHz, T.H.D. 0.08%)
Practical maximum output: Front: 35 W + 35 W (6 Ω/ohm load, 1 kHz)
Output terminals: Speaker impedance: 6 to 16 Ω/ohms
• Analog Section
Input sensitivity/Input impedance: 200 mV/47 kΩ/kohms
Frequency response: 10 Hz to 50 kHz: +0, –3 dB (2 Channel setting, direct mode)
Signal-to-noise ratio: 98 dB (Direct mode)
Rated output: 0.6 V (Subwoofer PRE OUT)
2 Tuner Section
Reception frequency range: FM:
87.5 MHz to 107.9 MHz
AM: 520 kHz to 1710 kHz
Receiving sensitivity: FM: 1.5 µV/75 Ω/ohms AM: 20 µV
FM stereo separation: 35 dB (1 kHz)
• Digital Section
Digital input/output: Format — Digital audio interface
2 Video Section
• Standard Video Jack
Output level/impedance: 1 Vp-p/75 Ω/ohms
• S-video Connector
Output level/impedance: Y (Brightness) signal — 1 Vp-p/75 Ω/ohms
C (Color) signal — 0.286 Vp-p/75 Ω/ohms
• Color Difference (Component)
Video Connector:
Output level/impedance: Y (Brightness) signal — 1 Vp-p/75 Ω/ohms
C
B/PB (Blue) signal — 0.7 Vp-p/75 Ω/ohms
CR/PR (Red) signal — 0.7 Vp-p/75 Ω/ohms
2 DVD Section
Signal Format: NTSC/PAL
Supported Discs: (1) DVD-VIDEO discs
12 cm single side 1 layer, 12 cm single side 2 layers,
12 cm both sides 2 layers (single side 1 layer),
8 cm single side 1 layer, 8 cm single side 2 layers,
8 cm both sides 2 layers (single side 1 layer)
(2) Compact Disc (CD-DA, VIDEO CD)
12 cm discs, 8 cm discs
Analog Audio Output: Output level: 1.2 Vrms (LINE-1, LINE-2 OUT)
2 Clock/Timer Section
Clock method: Power line frequency synchronized method
Timer: Everyday/Once timer: One system each
Sleep timer: 120 minutes, maximum
2 General
Power supply: 120 V AC, 60 Hz
Power consumption: 75 W
(At standby: Approximately 0.7 W)
Maximum external dimensions: 210 (W) x 95 (H) x 367 (D) mm (8-17/64” x 3-47/64” x 14-29/64”)
(including feet, knobs, and connectors)
Weight: 3.5 kg (7 lbs 11 oz)
2 Remote Control Unit RC-936
Remote control method: IR pulse method
Power supply: 3 V DC, using two AA batteries