Filter
Top Products
ENGLISH
Getting Started Operation Troubleshooting Specifications
Direction of broadcasting station
AM loop antenna
(Supplied)
Ground
AM outdoor antenna
FM antenna
(Supplied)
An F-type FM antenna can be connected directly.
FM outdoor antenna
75 Ω/ohms
coaxial cable
Black White
Connecting the antenna terminals
NOTE
•
Do not connect two FM antennas simultaneously.
• Even if an AM outdoor antenna is used, do not
disconnect the AM loop antenna.
• It is not possible to receive AM broadcasts with
good quality if the AM loop antenna is near
something metallic.
NOTE
• Use speakers with an impedance of 4 to 16 Ω/ohms.
• When making connections, take care that none of the strands in the speaker cable come in contact with
adjacent terminals, other speaker cable strands, or with the rear panel and screws.
NEVER touch the speaker terminals when the power is on. Doing so can result in electric shocks.
Protection circuit
When using speakers with an impedance below the designated value (for example 3 Ω/ohms), playing
for long periods of time with the volume high can cause the temperature to rise, activating the protection
circuit.
When this circuit is activated, the output to the speakers is cut off and the power indicator blinks. If this
happens, unplug the power cord, wait for the set to cool off and improve ventilation around the unit. Also
check the wiring of the input cables and the speaker cables. After doing this, plug the power cord back in
and turn the unit’s power back on.
If the protection circuit is activated again even though there are no problems with the wiring or the
ventilation around the unit, switch off the power and contact a DENON service center.
AM loop antenna assembly
Remove the vinyl tie and take
out the connection line.
Connect to the AM
antenna terminals.
Bend in the reverse direction.
a. With the antenna on top of
any stable surface.
Mount
b. With the antenna attached
to a wall.
Installation hole Mount on wall, etc.
Connection of AM antennas
1. Push the
lever.
2. Insert the
conductor.
3. Return the
lever.
Connections
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC
which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building, as close to the point of cable entry as practical.
1.DRA-CX3E3_ENG.indd 9 2008/02/22 10:20:14