Denon DRA-CX3 Stereo Receiver User Manual


 
ENGLISH
Connections Operation Troubleshooting Specifications
The included remote control unit (RC-1060) can be used to control the
DENON DCD-CX3 Super Audio CD player in addition to the DRA-CX3
(vpage 4).
q Remove the remote control
unit’s rear cover.
w Set two R03/AAA batteries in
the battery compartment in
the indicated direction.
e Put the rear cover back on.
30°
30°
Approx. 23 feet / 7 m
• Point the remote control unit at the remote sensor when operating
it.
• The remote control unit can be used from a distance of up to about
23 feet / 7 meters, at a horizontal angle of up to 30° with respect to
the sensor.
About the remote control unit
Inserting the batteries
NOTE
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit. (The
supplied batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper direction,
following the “q” and “w” marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
• If the battery fluid should leak, carefully wipe the fluid off the inside
of the battery compartment and insert new batteries.
• Remove the batteries from the remote control unit if it will not be in
use for long periods.
Operating range of the remote control
unit
NOTE
The set may function improperly or the remote control unit may not
operate if the remote control sensor is exposed to direct sunlight,
strong artificial light from an inverter type fluorescent lamp or infrared
light.
Getting Started
1.DRA-CX3E3_ENG.indd 5 2008/02/22 10:20:09