Filter
Top Products
ENGLISH
Getting Started Connections Operation Specifications
If a problem should arise, first check the following:
1. Are the connections correct ?
2. Is the set being operated as described in the operating instructions ?
3. Are the other components operating properly ?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Symptom Cause Measures Page
When the power
is turned on, the
power indicator
does not light
and no sound is
produced.
• The power cord’s plug is not fully
plugged in.
• Check the insertion of the
power cord plug and connected
securely.
8
The power
indicator lights
but no sound is
produced.
• The speaker cables are not
properly connected.
• The function (input) is incorrect.
• The volume is set too low.
• Connect securely.
• Switch to the correct function
(input).
• Adjust the volume to an
appropriate level.
5
9
9
No sound is
produced from
one side.
• The speaker cables are not
properly connected.
• The input cables are not properly
connected.
• The left/right balance is off.
• Connect securely.
• Connect securely.
• Adjust the left/right balance.
5
6, 7
9
For stereo
sources, the
positions of the
instruments are
inverted.
• The connections of the speaker
cables or input cables are
inverted.
• Check and remedy the
connections.
5
Buzzing noise in
FM broadcasts.
• The antenna cable is not properly
connected.
• Noise interference from a nearby
electronic device equipped with
a microprocessor, or the radio
broadcast signal is weak.
• Connect the antenna properly.
• Reposition the equipment or the
positions or directions of the
connection cables, antenna, etc.
• Connect an outdoor antenna.
6
6
6
Troubleshooting
Symptom Cause Measures Page
Hissing or buzzing
noise is heard in
AM broadcasts.
• Noise interference from a
nearby monitor, etc., or there
is interference in the broadcast
signal.
• Turn off the monitor.
• Change the position or direction
of the AM loop antenna.
• Connect an outdoor antenna.
–
6
6
Humming noise
is heard in AM
broadcasts.
• There is interference from
current in power cords.
• Connect an outdoor antenna. 6
When playing
records, a wailing
noise (howling) is
produced when
the volume is
raised.
• The player and speakers are too
close together.
• The floor is soft and vibrates
easily.
•
Move the player and speakers as
far apart as possible.
• Use cushions or spikes to absorb
the vibrations of the speakers
being conveyed from the floor.
7
–
Remote control
unit does not
operate.
• The batteries are flat.
• The remote control unit is too far
away.
• There is an obstacle between the
main unit and the remote control
unit.
• The remote control unit is being
operated at an angle of over 30°
with respect to the front panel.
• The batteries are inserted in the
wrong direction.
• Replace with new batteries.
• Operate from closer to the main
unit.
• Remove the obstacle.
• Operate the remote control unit
from directly in front of the main
unit.
• Insert the batteries in the proper
direction.
2
2
2
2
2
Troubleshooting
1.DRA-CX3E3_ENG.indd 15 2008/02/22 10:20:19