Filter
Top Products
ENGLISH
ENGLISH
53
System Setup System Setup
2
Press the CURSOR
•
or
ª
button to select
“CHANNEL LEVEL”, then press the ENTER
button.
• The channel level setting screen appears.
3
Press the CURSOR 0 or 1 button to select
“AUTO”, “MANUAL” or “OFF” for the
“TEST TONE” mode, then press the ENTER
button.
AUTO:
Adjust the levels listening to test tones automatically output
from the different speakers.
MANUAL:
Select the speakers from which the test tones are output
when adjusting the levels.
OFF (Factory default):
The test tones are not output.
Detailed settings can be made when this is set to
“MANUAL” first.
Setting “CHANNEL LEVEL”
• Adjust so that the playback levels of the different channels are
equal.
• Make this adjustment by listening to the test tones output from
the speakers at the listening position.
Use the VOLUME control knob on the main unit or the VOLUME
buttons on the remote control unit to adjust the volume of the
test tone to a level at which it is easy to make this adjustment.
1
Press the CURSOR
•
or
ª
button to select
“SPEAKER SETUP” at the “AUDIO SETUP”,
then press the ENTER button.
• The “SPEAKER SETUP” screen appears.
• When the channel levels are adjusted at the channel level
settings, the adjusted values are applied to all playback modes.
4
-1
When “AUTO” mode is selected:
Press the CURSOR 0 or 1 button to adjust all
the speakers to the same volume.
•Test tones are automatically output from the speakers at
intervals of 4 seconds for two of the cycles shown
below, then at intervals of 2 seconds from the third
cycle on.
4
-2
When “MANUAL” or “OFF” mode is selected:
Press the CURSOR
•
or
ª
button to select the
speaker, then press the CURSOR 0 or 1 button
to adjust all the speakers to the same volume.
The level changes in units of 1 dB each time the
CURSOR
00
or
11
button is pressed.
The level can be adjusted in the range –12 dB to +12
dB.
5
Press the ENTER button twice.
•The “SPEAKER SETUP” screen appears.
Front left Front right
Subwoofer
7
Press the CURSOR
ª
button to select “NEXT
SETUP MENU”, then press the ENTER to enter
the setting.
• The next screen in the “SETUP” menu screen appears.
6
Press the CURSOR
ª
button to select “SETUP
MENU”, then press the ENTER button.
• The “AUDIO SETUP” screen appears.