Filter
Top Products
ENGLISH
ENGLISH
13
Easy Setup and Operation
Playing a DVD disc
1
Check that all connections are correct.
Disc tray
• Pick up the disc carefully so as not to touch the signal surface and hold it with the labeled side facing up.
•With the disc tray fully open, set the disc in the disc tray.
Press the
55
button to set the DVD disc in the
disc tray.
4
2
Turn on your monitor (TV).
Switch the input selector on the TV to this unit.
The disc tray can also be closed automatically to load the
disc by pressing the
11
button. After this, playback starts
automatically.
Press the
55
button.
5
Press the
11
button.
6
VOLUMEON/STANDBY
5 12
VOLUME
ON/STANDBY
MUTE
1
2
3
Press the ON/STANDBY switch.
• The power indicator lights blue, the power turns on and
the display lights.
Several seconds are required from the time the ON/STANDBY
switch is pressed until the power turns on. This is due to the
built-in muting circuit that turns off (mutes) the sound when
the power is turned on and off. The power indicator flashes
blue while the muting circuit is activated.
Even when the ON/STANDBY switch has been pressed again
and the power has been set to the standby mode, power is
still supplied to some circuits. When leaving home or
traveling, be sure to unplug the power supply cord from the
power outlet. In the standby mode, the power indicator is
lights red. The indicator is orange when the timer is set.
Easy Setup and Operation