Filter
Top Products
29
ENGLISH
Basic Operation Basic Operation
ENGLISH
2
Press the SURROUND button to select the
surround mode.
• The surround mode switches as shown below each
time the SURROUND button is pressed.
STEREODOLBY VS WIDEDOLBY VS REF.
ROCK ARENAJAZZ CLUB
4
Start playback on the selected component.
The volume can be adjusted within the range –60 to 0 to
+18 dB. Note that depending on the input signal, surround
mode, speaker settings and channel level setting, it may not
be possible to adjust the volume up to +18 dB.
Function setting
1
Press the FUNCTION button on the main unit,
and DVD, TUNER or AUX button on the remote
control unit to select the input function to be
played.
• The function switches as shown below.
When the FUNCTION button on the main unit is pressed:
iPodTUNERDVD
AUX1
AUX3 AUX2
Portable
When the AUX button on the remote control unit is
pressed:
AUX3 AUX2
iPod
Portable
AUX1
iPod and Portable are only displayed and selectable
when the corresponding components is connected.
(Main unit) (Remote control unit)
For operating instructions, refer to the component’s manual.
5
Adjust the volume.
The volume is shown on
the display.
(Main unit) (Remote control unit)
2 To check the currently playing program
source, etc.
Press the STATUS button.
• The current program source and surround settings are shown
on the display each time the button is pressed.
FUNCTION
VOLUME
CURSOR
SURROUND
SURROUND
PARAMETER
STATUS
CURSOR
AUX
VOLUME
DVD
TUNER
DVS/CINEMA
3
When “STEREO” is selected:
Press the SURROUND PARAMETER button,
then press the CURSOR 0 or 1 button to set.
DIRECT ON OFF
DIRECT MODE:
• ON:
The analog input signals are played without DSP processing.
The settings made at “DISTANCE” under “SETUP” (
page 48) are not reflected.
• OFF:
The analog input signals are converted into digital signals and
undergo DSP processing.
The “DIRECT MODE” only functions with analog inputs and
in the stereo mode.
2 Surround parameters q
• DOLBY DIGITAL • DTS
2 Input signal display