Filter
Top Products
12
ENGLISH
ENGLISH
Easy Setup and Operation Easy Setup and Operation
Inserting the batteries
q Remove the remote control unit’s rear
cover.
w Set two R6P/AA batteries in the
battery compartment in the indicated
direction.
e Put the rear cover back on.
Notes on batteries:
• Use R6P/AA batteries in the remote control unit.
• The batteries should be replaced with new ones
approximately once a year, though this depends
on the frequency of usage.
• Even if less than a year has passed, replace the
batteries with new ones if the set does not
operate even when the remote control unit is
operated nearby the set. (The included battery is
only for verifying operation. Replace it with a new
battery as soon as possible.)
• When inserting the batteries, be sure to do so in
the proper direction, following the “<” and “>”
marks in the battery compartment.
•To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old
one.
•Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or
dispose of batteries in flames.
• Remove the batteries from the remote control
unit when you do not plan to use it for an
extended period of time.
• If the battery fluid should leak, carefully wipe the
fluid off the inside of the battery compartment
and insert new batteries.
•When replacing the batteries, have the new
batteries ready and insert them as quickly as
possible.
AC outlets (wall)
AC 120 V, 60 Hz
The S-101 includes a built-in clock
function, so plug its power supply
cord into a wall AC outlet to
which electricity is supplied
constantly.
DSW-S101
1
Power supply cord
2
Connecting the power supply cord