Filter
Top Products
185
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Levels
Set the volume of the test tone to be the same when it is output from
each speaker.
2 Test Tone Start
Output test tone. A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0dB – +12.0dB (Default : 0.0dB)
%
•When “Levels” is adjusted, the adjusted values are set for all the sound
modes.
•When headphones are connected to the PHONES connector on this unit, you
cannot set “Levels”.
2 Set Defaults
The “Levels” settings are returned to the default settings.
Crossovers
Set the maximum frequency of the bass signal output from each channel to
the subwoofer. Set the Crossover Frequency to suit the bass reproduction
capability of the speaker being used.
2 Speaker Selection
Selects how to set the crossover frequency. See the speaker manual
for information concerning speaker crossover frequency.
All (Default) : Selects the crossover point of all speakers at the same
time.
Individual : Selects the crossover points for each speaker individually.