Filter
Top Products
175
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
3
Connect the Setup and measurement microphone to
the SETUP MIC jack of this unit.
Audyssey Setup
Channel Select
Amp Assign
Check Results
Restore...
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
When the Setup and measurement
microphone is connected, the
following screen is displayed.
4
Select “Start” and then press ENTER.
Audyssey® Setup can also make the following settings.
•Amp Assign
The signal output from the SURROUND BACK, FRONT HEIGHT
and FRONT WIDE speaker terminals of this unit can be switched
to match your speaker environment. Refer to “Amp Assign”
(vpage181).
•Channel Select
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of surround
back speakers and subwoofer.
5
Select “Next” and then press ENTER.