Denon AVR-2106 Stereo Amplifier User Manual


 
54
Specifications
2 Audio section
Power amplifier
Rated output: Front: 90 W + 90 W
(8 /ohms, 20 Hz ~ 20 kHz with 0.08% T.H.D.)
125 W + 125 W
(6 /ohms, 1 kHz with 0.7% T.H.D.)
Center: 90 W
(8 /ohms, 20 Hz ~ 20 kHz with 0.08% T.H.D.)
125 W
(6 /ohms, 1 kHz with 0.7% T.H.D.)
Surround: 90 W + 90 W
(8 /ohms, 20 Hz ~ 20 kHz with 0.08% T.H.D.)
125 W + 125 W
(6 /ohms, 1 kHz with 0.7% T.H.D.)
Surround Back: 90 W + 90 W
(8 /ohms, 20 Hz ~ 20 kHz with 0.08% T.H.D.)
125 W + 125 W
(6 /ohms, 1 kHz with 0.7% T.H.D.)
Dynamic power: 120 W x 2 ch (8 /ohms)
170 W x 2 ch (4 /ohms)
200 W x 2 ch (2 /ohms)
Output terminals: Front: A or B 16 ~ 16 /ohms
A + B 12 ~ 16 /ohms
Center, Surround, Surr.Back: 16 ~ 16 /ohms
Analog
Input sensitivity /
input impedance: 200 mV / 47 k/kohms
Frequency response: 10 Hz ~ 100 kHz: +1, –3 dB (DIRECT mode)
S/N: 100 dB (IHF-A weighted) (DIRECT mode)
Distortion: 0.008 % (20 Hz ~ 20 kHz) (DIRECT mode)
Rated output: 1.2 V
Phono equalizer (PHONO input — REC OUT)
Input sensitivity: 2.5 mV
RIAA deviation: ±1 dB (20 Hz to 20 kHz)
S/N: 74 dB (A weighting, with 5 mV input)
Rated output /
Maximum output: 150 mV / 7 V
Distortion factor: 0.03 % (1 kHz, 3 V)
2 Video section
Standard video terminals
Input / output level
and impedance: 1 Vp-p, 75 /ohms
Frequency response: 5 Hz ~ 10 MHz — +1, –3 dB
S-Video terminals
Input / output level
and impedance: Y (brightness) signal — 1 Vp-p, 75 /ohms
C (color) signal — 0.3 Vp-p, 75 /ohms
Frequency response: 5 Hz ~ 10 MHz — +1, –3 dB
Color component video terminal
Input / output level
and impedance: Y (brightness) signal — 1 Vp-p, 75 /ohms
PB/CB (blue) signal — 0.7 Vp-p, 75 /ohms
PR/CR (red) signal — 0.7 Vp-p, 75 /ohms
Frequency response: DC ~ 100 MHz — +0, –3 dB
2 Tuner section [FM] (note: µV at 75 /ohms, [AM]
0 dBf=1 x 10
–15
W)
Receiving Range: 87.50 MHz ~ 108.00 MHz 522 kHz ~ 1611 kHz
Usable Sensitivity: 1.0 µV (11.2 dBf) 18 µV
50 dB Quieting
Sensitivity: MONO 1.6 µV (15.3 dBf)
STEREO 23 µV (38.5 dBf)
S/N (IHF-A): MONO 77 dB (IHF-A weighted)
STEREO 72 dB (IHF-A weighted)
Total Harmonic Distortion
(at 1 kHz): MONO 0.15 % (1 kHz)
STEREO 0.3 % (1 kHz)
2 General
Power supply: AC 230 V, 50 Hz
Power consumption: 450 W
Maximum external
dimensions: 434 (W) x 171 (H) x 417 (D) mm
Mass: 12.8 kg
2 Remote control unit (RC-1016)
Batteries: R6P/AA Type (two batteries)
External dimensions: 55 (W) x 225 (H) x 34.5 (D) mm
Mass: 165 g (including batteries)
* For purposes of improvement, specifications and design are subject to change without notice.
Specifications