Denon AVR-2106 Stereo Amplifier User Manual


 
42
Advanced Setup – Part 2Advanced Setup – Part 2
2
Press the CURSOR
DD
or
HH
button to select the
speaker to be set.
3
Press the CURSOR
FF
or
GG
button to set the
distance between the speaker and the listening
position.
The distance changes in units of 0.1 meters each time the
button is pressed. Select the value closest to the measured
distance.
If “Yes” is selected for “Default”, the settings are
automatically reset to the default values.
The difference in distance for the various speaker
settings must not be greater than 6.0 meters.
4
Press the ENTER button to enter the setting.
The “Speaker Setup” menu appears.
1
Press the CURSOR
DD
or
HH
button to select
“Delay Time” at the “Speaker Setup” menu,
then press the ENTER button.
The “Delay Time” screen appears.
Use this setting to balance the playback levels in different
channels and make them appear equal.
•From the listening position, listen to the test tones produced
from the speakers to adjust the level.
The levels can also be adjusted directly from the remote control
unit ( page 43).
Setting the Channel Level
1
Press the CURSOR
DD
or
HH
button to select
“Channel Level” at the “Speaker Setup” menu,
then press the ENTER button.
The “Channel Level” screen appears.
2
Press the CURSOR
FF
or
GG
button to select
“Auto” or “Manual”.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Manual:
Select the speaker from which you want to produce the test
tone to adjust the level.
3
Press the CURSOR
DD
or
HH
button to select
“TEST TONE Start”, then press the CURSOR
FF
button to select “Start”.
4
-1
When “Auto” mode is selected:
Press the CURSOR
FF
or
GG
button to adjust all
the speakers to the same volume.
The test tones are emitted from each speaker in the
following order: at 4-second intervals during the first and
second cycle, and at the 2-second intervals during the
third and subsequent cycles.
FL
SW
1sp
2sp
C
FR
SR
SBL
SL
SB
SBR
When the surround back speaker setting is set to
“1sp” for “Speaker Configuration”, this is set to “SB”.
Example:
When the volume is set to –12.0 dB while the test tone
is being produced from the Front Lch speaker
4
-2
When “Manual” mode is selected:
Press the CURSOR
DD
or
HH
button to select the
speaker, then press the CURSOR
FF
or
GG
button
to adjust all the speakers to the same volume.
The volume can be adjusted between –12 dB and +12
dB in units of 0.5 dB.
5
Press the ENTER button to enter the setting.
The “Speaker Setup” menu appears.