Filter
Top Products
Installing the VoIP Ceiling Speaker
Configure the Speaker Parameters
Operations Guide 930095K CyberData Corporation
15
3. After changing the parameters, click Save Settings.
2.3.4 Configure the SIP Parameters
1. Click SIP Setup to open the SIP Setup page (Figure 2-9).
Note For spec
ific server configurations, go to the following URL:
http://www.cyberdata.net/support/voi
p/ceilingspeaker.html
Note If
the speaker is set up for MGROUPS, the SIP settings will be grayed out.
RTFM Announcement
a
Enable/Disable the speaker tone (beep) and audio
associated with the RTFM switch.
Click on this button to save your configuration settings.
Click on this button to do an audio test. Generates a voice
message for testing the speaker audio quality and volume.
Link to the Network Setup page.
Link to the SIP Setup page.
Link to the MGROUPS Setup page.
Link to the Upgrade Firmware page.
Link to the Home page.
a.If you select No for RTFM Announcement, you will not hear a beep or associated RTFM audio.
However, the return to default settings function remains active. If you wish to return to default
settings, hold the RTFM button at least 20 seconds, then release the button.
Table 2-6. Speaker Setup Parameters
Web Page Item Description