Filter
Top Products
Installing the VoIP Ceiling Speaker
Speaker Setup
Operations Guide 930095K CyberData Corporation
7
2.2.2 Confirm that the Speaker is Operational and Linked to the Network
After connecting the speaker to the 802.3af compliant ethernet hub, the LEDs on the speaker face
confirm that the speaker is operational and linked to the network.
Figure 2-3. Status and Activity LEDs
2.2.2.1 Status LED
After supplying power to the speaker:
1. The green St
atus LED illuminates after approximately five seconds to indicate the start of the
firmware verification and load process.
2. After approximately 15 seconds, the Stat
us LED begins to blink at one second intervals to
indicate the start of the firmware boot process.
3. After approximately 35 seconds, the speaker beeps once to
indicate that it is operational.
4. The St
atus LED will continue to blink at one second intervals to indicate normal operation.
2.2.2.2 Link LED
● The Link LED is illuminated when the network link to the speaker is established.
● The Link LED blinks to indicate network traffic.
Speaker
Status
(Green)
Network
Link/Activity
(Yellow)