Filter
Top Products
InfiNET™ TableTop Controller Crestron HTT-B10X
Auto Dimming Backlight
High quality backlit laser engraving provides customizable button text that is easy to
read under any lighting condition. A built-in light sensor controls the backlight
intensity automatically to achieve a crisp, legible appearance in both darkened and
fully lit rooms.
True Feedback
Elegant white LED light pipes beside each button provide reliable status feedback
for everything from lighting presets to motorized windows and door locks. Ten
different blink patterns are built in, enabling all kinds of blinking LED feedback
while simplifying programming and minimizing traffic on the infiNET network.
Additional bar graph capability uses the same LEDs to display actual level settings in
the form of two vertical five segment bar graphs. True feedback for every status and
level setting is achieved via infiNET’s fully bidirectional wireless protocol. The
overall LED intensity is auto-dimmable, adjusting automatically for optimal
visibility under varying lighting conditions.
Battery or AC Powered
The HTT-B10X can be powered by its external power pack or two AA batteries,
permitting use as a stationary controller on a desk or table or as a portable wireless
remote. Its auto-sleep function affords battery operation for up to eight months on a
single set of alkaline batteries. Simply moving or pressing a button on the
HTT-B10X instantly wakes it from sleep mode. Connecting the power pack
overrides the sleep/wake function completely for “always on” operation.
InfiNET™
Crestron’s groundbreaking infiNET wireless technology affords reliable two way
communications throughout a home or office structure without the need for physical
control wiring. Numerous infiNET controllers, dimmers, thermostats and other
devices can be linked to a central control system via a single RF gateway. Employing
a 2.4 GHz mesh network topology, each infiNET device functions as an RF repeater,
increasing effective range and reinforcing the complete network by providing
multiple redundant signal paths within the mesh network.
NOTE: The HTT-B10X itself does not function as a repeater.
Easy Installation
Setting up a complete network of infiNET devices including the HTT-B10X is
simple. The C2N-MNETGW gateway (sold separately) utilizes discovery (self
install) to locate and acquire each infiNET device automatically. Setting the RF ID
of each device employs the same convention as Crestron’s familiar TSID method
and each device is programmable using Crestron SIMPL™ Windows
®
,
SystemBuilder™ or D3Pro™ software just like any wired Cresnet
®
device. Even
firmware updates are performed over the wireless network.
No further action is required to configure the infiNET network. Each device assigned
to a common gateway automatically behaves as a repeater for any other devices
within range, approximately 150 feet (46 meters) indoors and additional repeaters
may be added if necessary. At all times, the infiNET gateway monitors each device
on the network, ignoring any other 2.4 GHz signals and reconfiguring the entire
network automatically in response to new sources of interference and other changes
in RF conditions.
2 • infiNET™ TableTop Controller: HTT-B10X Operations Guide – DOC. 6583B