Filter
Top Products
8
register your purchase! Having found the serial number, now would be a good time to fi ll out the
registration card. Please register your purchase so we can advise you of updates
and other items of interest.
It will take only a minute or so. Please complete the card now, before you forget.
operating voltage e CAP-2100 integrated amplifi er is set at the factory for 100V, 120V, 220V,
230V, or 240V AC mains operation, as appropriate for the country in which
it is to be sold (230V only in European Union countries, in compliance with CE
regulations.) e voltage setting may not be changed by the user.
Make sure that the label on the rear panel of your power amplifi er indicates
the correct AC operating voltage for your location. Attempting to operate your
power amplifi er at an incorrect voltage may damage the unit.
Warning: The voltage setting of your power amplifier may not
be changed by the user. There are no user-serviceable
parts within the unit. Please refer any problems to an
authorized Classé service center.
If the AC mains voltage indicated on your integrated amplifi er is incorrect,
please contact your local, authorized Classé dealer or distributor.
e CAP-2100 can easily be powered by a normal 15-ampere AC mains line.
If other devices are also powered from the same AC line, their additional power
consumption should be taken into account.
e CAP-2100 includes protection circuitry that will prevent the integrated
amplifi er from operating at dangerously high or low voltages.
• At startup: the AC mains voltage must be within a range of
approximately -15% to +10% of its nominal value at startup, or
the amplifi er will not turn on. For example, a 120V unit requires
the AC mains to be between approximately 95V–135V in order to
turn on.
• Over-voltage during operation: if the AC mains voltage surges
by roughly 10% or more during operation, the amplifi er will enter
protection mode and shut down. e Standby LED will fl ash to
indicate the protection mode has been engaged.
• Under-voltage during operation: if the AC mains voltage sags by
15% or more, the amplifi er will continue to play (since this does
not present a particular danger to the amplifi er), but note that
it may not be able to achieve its usual standard of performance
under these compromised conditions. e Standby LED will fl ash
to indicate the condition.