Filter
Top Products
19
12 AC Mains Fuse
An AC mains fuse holder is located next to the AC mains input. It is
unlikely that you should ever have to replace this fuse, but if you do, it is
critical that you do so only with a fuse of exactly the same rating and value
(specifi ed in Troubleshooting #8).
Important! Never replace a blown fuse on this or any other piece of
electronics with anything other than a fuse of exactly the
same rating and value. Doing so can cause damage to your
electronics that may not be covered by the warranty.
.
Always disconnect the integrated amplifier from the AC
mains and from the speakers before attempting to replace
a fuse. If the fuse blows again upon powering back up,
contact your authorized Classé dealer for assistance.
.
There are no user-serviceable parts inside the CAP-2100.
13 AC Mains Input
An IEC standard power cord (supplied) is used with the CAP-2100.
Plug the cord into the IEC receptacle provided, and the other end into a
suitable wall outlet.
14 AC Mains Power Switch
e main power switch for the CAP-2100 is located near the middle of
the rear panel, beside the receptacle for the power cord.
e integrated amplifi er should be in standby before being switched off .
Switching the unit on puts it in standby mode.
Danger! Potentially dangerous voltages and current capabilities
exist within your integrated amplifier, even when
disconnected from AC mains. Do not attempt to open any
portion of the integrated amplifier’s cabinet. There are no
user-serviceable parts inside your integrated amplifier.
All service of this product must be referred to a qualified
authorized Classé dealer or distributor.