Classe Audio CAP-2100 Stereo Amplifier User Manual


 
43
Specifications
All specifi cations are accurate at the time of printing. Classé reserves the right to
adjust specifi cations without notice.
Power output (both channels driven) 100W/ch continuous rms @ 8Ω
200W/ch continuous rms @ 4Ω
Frequency response 10Hz – 22kHz (+0/-0.1dB)
10Hz – 155kHz (+0/-3.0dB)
Phase less than -10° @ 22kHz
Signal-to-noise ratio 95dB typical
Channel separation better than 95dB @ 20kHz
Noise floor (FFT) all peaks less than -90dBV
(10Hz – 80kHz)
Distortion (THD + noise) 0.005% @ 8Ω
(unweighted, 0.8Vrms/1kHz input, 10Hz – 80kHz)
Maximum input voltage 3.8Vrms (single-ended)
7.8Vrms (balanced)
Voltage gain range -100dB to +14dB
Sensitivity (SSP input) 0.5Vrms for rated output (single-ended)
1.0Vrms for rated output (balanced)
Input Impedance 100kΩ
Output Impedance (main output) 100Ω
Input complement 1 balanced (XLR), 4 single-ended (RCA)
Output complement 2 single-ended (RCA)
Crosstalk (any input to any output) better than -95dB
Rated power consumption
(as per IEC60065 - para.2.3.10) 260W
Idle power consumption 125W
Mains voltage specifi ed on rear panel decal
(cannot be changed by user or dealer)
Dimensions (not incl. controls or connectors) Width: 17.5” (445mm)
Height: 4.75” (121mm)
Depth: 16.5” (419mm)
Shipping weight 59lbs (27kg)
Net weight 50lbs (23kg)
For more information, see your Classé dealer, or contact:
Classé Audio
5070 François Cusson
Lachine, Quebec
Canada H8T 1B3
Telephone +1 (514) 636-6384
FAX +1 (514) 636-1428
Internet: http://www.classeaudio.com
email: cservice@classeaudio.com
Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command™ is a trademark of Equity International, Inc. All rights reserved.
AMX® is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved.
Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved.