Clark Synthesis TA0.1 Stereo Amplifier User Manual


  Open as PDF
of 28
 
www.clarksynthesis.com
TA0.1 Amplier
22
SPECIFICATIONS
General
Power Supply................................................................................................................100 – 240 VAC, 50/60 Hz, Auto•
Standby Current (110 VAC / 220 VAC)....................................................................................................0.12 A / 0.11 A•
Max Current (110 VAC / 220 VAC)..............................................................................................................2.4 A / 1.1 A•
Total Amplier Efciency..........................................................................................................................................70%•
• Dimensions (Amplier) (W x H x D)...........................5.125 in x 2.75 in x 8.875 in (130.2 mm x 69.9 mm x 225.4 mm)
Dimensions (Remote Control Interface) (W x H x D)........................5 in x 2.125 in x 2 in (127 mm x 54 mm x 50 mm)•
Remote Control Wire Length...................................................................................................................... Approx. 4 ft.•
Weight................................................................................................................................................4.0 lbs. (1.814 kg)•
Fuse..............................................................................................................................................................T3AL 250V•
Input Section
Input Impedance...................................................................................................................................................16 kΩ•
Input Sensitivity (1 W, Input switch set to Low)...................................................................................................30 mV•
Input Sensitivity (1 W, Input switch set to High)................................................................................................100 mV•
Input Sensitivity (150 W, Input switch set to Low).............................................................................................360 mV•
Input Sensitivity (150 W, Input switch set to High)...................................................................................................1 V•
Loop Through Amplication.......................................................................................................................................x 1•
Auto-On..............................................................................................................................................Switch Selectable•
Crossover Section
• Crossover Frequency Selection.............................................................................................................40 Hz – 400 Hz
Crossover Frequency Selection (+ 0 dB, -3 dB)....................................................................................35 Hz – 420 Hz•
Amplier Section
• Output Power....................................................................................................................150 Watts RMS into 4 Ohms
Total Harmonic Distortion (at 1 Watt into 4Ω).......................................................................................................0.15%•
Total Harmonic Distortion (at 150 Watts into 4Ω).................................................................................................0.08%•
• Frequency Response..............................................................................................................................5 Hz to 36 kHz
Frequency Response (+0 dB, -3 dB)....................................................................................................28 Hz to 36 kHz•
Amplier- Input/Output Panel View
2.75 in
(69.9 mm)
5.125 in (130.2 mm)
Amplier- Side View
.875 in
(22.2 mm)
.125 in
(3.17 mm)
7.375 in (187.3 mm)
8.625 in (219.1 mm)
 previous next