Filter
Top Products
TA0.1 Amplier
19
www.clarksynthesis.com
SETTING UP YOUR AMPLIFIER
The TA0.1 has powered loop-through. This feature enables the user to take the signal from an audio
source and pass it to a series of TA0.1 ampliers in order to drive multiple transducers.
The drawing for this type of hookup is shown below. Use a standard “Y” adapter to get the signal from
the audio source (e.g., from the LFE/SUB output). If the input signal is coming from two ports (e.g.,
from the RF and LF outputs), the “Y” adapter is not needed. The wires from those connectors can be
connected directly to the “Audio In” connectors of the TA0.1.
Subsequent wiring between the ampliers can be done with single or paired wire connectors. The
wiring for the transducers is the same as that for a single transducer hookup (see “Connecting the
Transducer to the Amplier” on the previous page).
Transducer #3Transducer #2Transducer #1
Audio Source
TA0.1 Amplier #3TA0.1 Amplier #2TA0.1 Amplier #1
Transducer OutputTransducer OutputTransducer Output
–––
+++
Using the Powered Loop-Through
to Run Multiple Transducers
L L L
R R R
OUT OUT OUT
IN IN IN