Filter
Top Products
TA0.1 Amplier
11
www.clarksynthesis.com
PRODUCT OVERVIEW
Input/Output Panel Overview
AUDIO INPUT/OUTPUT CONNECTORS
The Audio Input/Output Connectors accept standard RCA plugs. These connectors are split into
Left and Right channels, as indicated by L and R on the panel. The Left and Right sides each
have one Audio Out and one Audio IN.
HIGH/LOW INPUT SIGNAL SWITCH
The High/Low Switch allows the user to select the voltage level of the audio input source. For
example, if the input source is a standard home theater or stereo receiver, the switch should be
set to “High” (unless using the “Auto” setting). If the input source is an MP3 player or portable
CD player, or if you are running the amplier with the On/Auto/Off switch set to “Auto,” the switch
should be set to “Low.” For any other type of input source, begin by using the “High” setting. If
you are not receiving enough output, try the “Low” setting.
TRANSDUCER CONNECTOR
The Transducer Connector is used to connect the transducer to the amplier. This connector
uses 5-way binding posts, which allow for a variety of ways to connect the transducer wire (see
“Connecting the Transducer to the Amplier” on page 18).