Filter
Top Products
TA0.1 Amplier
15
www.clarksynthesis.com
SETTING UP YOUR AMPLIFIER
CAUTION: Before connecting any wires or input/output lines, insure all equipment is
off and no signals are being sent from the input device.
In order to reduce the chances of accidentally damaging the amplier or transducer, please set the
amplier controls to the safety positions described and shown below:
Set the • On/Auto/Off Switch to the “Off” position (see photo #1)
Set the • Gain (Volume) Control to “Min” (completely counter-clockwise, see photo #2)
Set the • Input Signal Switch on the back of the amplier to the “High” position (see photo #3)
Photo #3
Photo #1
Photo #2
!
Initial Settings Prior to Making Connections