Filter
Top Products
www.clarksynthesis.com
TA0.1 Amplier
16
SETTING UP YOUR AMPLIFIER
HOME THEATER
There are several different ways to hook up your system in terms of which source material (signal)
is delivered to the amplier(s) and transducer(s). Since our inception, we have discovered that
approximately half of our customers prefer using the LFE/SUB signal with their transducers. The other
half prefer using the Right Front (RF) and Left Front (LF) signals. Additionally, there are a few people
who like to use multiple signals concurrently. In the following instructions, we provide you with general
diagrams for each of these hookup methods.
LFE/SUB Hookup
The LFE, SUB, or Subwoofer output is the signal that you send to the subwoofer.
If your receiver has only one LFE/SUB/Subwoofer output port, connect a “Y” adapter to that output.
This will allow you to split the signal between the transducer and the subwoofer. To do this properly,
connect your subwoofer to one side of the “Y” adapter. Connect the TA0.1 amplier to the other side
of the “Y” adapter. To reduce the amount of noise produced when using this signal, use another “Y”
adapter cable when connecting to the amplier. This will allow you to connect the signal into both the
Left and Right input connectors on the amplier.
L
R
OUT
LFE/SUB
IN
Y Adapter
To Input of
Powered
Subwoofer
Y Adapter
Subwoofer
Transducer
Transducer
Surround-Sound ReceiverTA0.1 Amplier
Transducer Output
–
+
Connecting the Audio Source