Filter
Top Products
3133501
Figure 5 - Diagram of AC power cable
Transmitter Feed
If using an SSPA with an N-type connector output, connect a section of coax between the OMT
transmit port and the SSPA’s transmit port.
If using a SSPA with a waveguide flange output port, connect a section of waveguide between the
OMT transmit port and the SSPA’s transmit output, TX OUT. A waveguide should be attached to the
antenna feed per manufacturer’s instructions. Ensure a gasket is fitted at each flange and that the
connections are weather-tight.
Driver Feed
Attach a coaxial cable with male N-connectors between the SSPA’s TX RF input and the 0
dBm driver’s RF OUTPUT. Make sure that the connections are weather-tight.
ANACOM AnaSat
®
SSPA 15