Filter
Top Products
3133501
Cable and Waveguide Connections
Cabling Requirements
Local regulations may require that cables in occupied buildings be installed in steel conduit. Local
government agencies may waive this requirement for the use of Plenum cables, which are standard
cables entirely encased in solid Teflon. Check the codes in your area.
NOTE: E
QUIPMENT OUTAGES DUE TO FAULTY CABLE MATERIALS OR INSTALLATION ARE NOT
COVERED BY YOUR WARRANTY
.
AC Power
Attach the AC input cable to the 4-pin connector on the SSPA, shown in Figure 4. Run the AC
cable to the power source but do not attach. The supplied power cable has a four-pin weather-
tight circular connector attached to one end. The other end is terminated with flying leads. Attach
the proper AC power connector for your location to the other end of this cable as shown in Figure
5 below.
Color code:
Brown..................AC Hot power lead
Blue......................AC Neutral power lead
Green/Yellow......Ground
Figure 4 - AC Power Connection
ANACOM AnaSat
®
SSPA 14