SP2 Remote Control continued...
1: SOURCE SELECT BUTTONS
These buttons are used to select the desired
source. TV/SAT, DVD, CD, AUX, VCR, and TAPE
function exactly like their corresponding buttons on
the SP2 front panel.
2: BYPASS BUTTONS
To use the 5.1 channel analog input, press the 6CH
BYPASS button. To go back to the previous select-
ed source, press the 6CH BYPASS button again.
To use the Stereo Bypass mode for the currently
selected source, press the 2CH BYPASS button. To
go back to the previous selected mode, press the
2CH BYPASS button again.
3: MODE SELECT BUTTONS
These buttons (THX, SURR, DIG, STEREO, MODE)
are used to change the SP2 decoding mode, and
function exactly like their equivalent buttons on the
front panel.
4: MUTE BUTTON
Pressing this button will fully mute the output of
the SP2.
5: VOLUME/TRIM BUTTONS
These buttons increase and decrease the master
volume. When the SP2 is in its Test/Noise mode,
these buttons are used to adjust the level trim for
each individual speaker.
6: TEST BUTTON
If pressed for more than 3 seconds, the SP2 will
enter the Test/Noise mode. Please see Page 18 for
more details on this mode.
7: POwER BUTTON
Pressing this button will toggle the SP2 in and out
of the Standby power mode.
Installers: please contact Bryston technical support
for information about Discrete On/Off control.
8: SAVE BUTTON
Pressing this button will memorize settings for the
current input, as described in “Saved Settings per
Source” on page 19.
9: DTS BUTTON
Pressing this button toggles between the DTS
Music mode, and the DTS Movie mode. These
modes are used ONLY when a DTS bitstream is
detected. The DTS Music mode is optimized to
provide proper playback of DTS encoded musical
material from DVD, LD or CD sources. DTS Movie
is available for playback of DTS encoded motion
picture soundtracks from DVD or LD sources. Each
mode has an optimized bass management setting
in accordance with the DTS program material.
10: DOLBY BUTTON
Pressing this button will engage the Dolby PLII
Film mode for any 2 channel sources (PCM, Dolby
Digital, or Analog).
11: SETUP BUTTONS
These include SUB, CENTER, OSD, REAR, BACK,
SELECT and MENU/UP/DOWN.
All of these setup functions can be accessed while
listening to movies or music.
SELECT, and buttons function like their
corresponding buttons on the SP2 front panel
(= and =). To enter the menu mode,
press any one of these buttons. If OSD is ON,
you will see the menu on your video monitor.
OSD (On-Screen Display) Button will toggle
the OSD function on and off, on your video
monitor, if you are using the Bryston video
switcher.
SUB button will engage the menu for the vol-
ume trim level of the subwoofer channel. Use
the MENU/UP/DOWN button to change the
subwoofer channel level up or down. Press
SELECT when finished.
CENTER button will engage the menu for the
volume trim level of the center channel. Use
the MENU/UP/DOWN button to change the
center channel level up or down. Press SELECT
when finished.
REAR button will engage the menu for the
volume trim level of the rear channels. Use
the MENU/UP/DOWN button to change the rear
channel levels up or down. Press SELECT when
finished.
BACK button will engage the menu for the vol-
ume trim level of the back channels. Use the
MENU/UP/DOWN button to change the back
channel level(s) up or down. Press SELECT
when finished.
12: STATUS LED
Indicates remote control status while accessing
discrete/hidden functions, and changing remote
options. Contact the factory for details.
13: PHOTO SENSOR
9