Filter
Top Products
31
Tab 6, 14
English Tab 2, 10 Tab 3, 11 Tab 4, 12 Tab 5, 13
Tab 8, 16Tab 7, 15
INSTALLATION
Mounting the aircraft panel connector
The aircraft panel connector is part of the optional 6-pin wiring harness
assembly.
Visit Bose.com or Global.Bose.com for information or purchase.
CAUTION: The aircraft panel connector must be mounted by a technician who is
qualified to perform this type of avionics installation for the aircraft you are using.
Mount the connector into a cutout, using the diagrams below as a guide.
Connect the eight wires as follows:
• Two for the microphone
• Two for audio
•One for power
• One for ground
• Two for audio shields
Audio and microphone wires should be connected to the back of the existing
microphone and headphone jacks, leaving existing jacks intact for use with
conventional headsets. This is usually the fastest installation method.
RED
•
1 V+IN
BLK
•
2 GND
WHT
•
3 COMM L
BLU
•
4 COMM R
WHT
•
5 MIC HI
WH/BLU
•
6 MIC LO
BLK/WH
BLK/WH
12.5mm
.49"
.55"
14.0mm
Pin 6
Pin 1
AIRCRAFT INTERFACE SCHEMATIC
RECEPTACLE - PINOUT (FRONT VIEW)
00_Cavu.book Page 31 Wednesday, April 25, 2012 10:10 AM