Filter
Top Products
A.
B.
C.
D
INSTALLATION INSTRUCTIONS
This car radio is designed to be installed in the car radio compartment provided by the vehicle
manufacturer. Open the car radio compartment (remove the shelf or panel by unclipping it) or
adjust the size of the car radio compartment to measure 182 x 53 mm.
The mounting bracket included with this car radio is designed for installation in vehicles with a
standard DIN installation compartment measuring 182 x 53 mm,
al65mm
installation depth and
an instrument panel thickness of approximately 1 to 20 mm in the area of the tab fasteners, see
Fig.
1.
Reach behind the car radio compartment and check to see which tab fasteners can be
bent on the mounting bracket. Place the mounting bracket in the compartment and bend over
the tabs with the help of a screwdriver, see Fig.
1,
2. Be sure to bend all of the tabs possible.
Your vehicle may also allow you to provide extra ability at the back of the unit. Look at the wall
behind the radio cavity to see if there is a small hole the size of the enclosed plastic plugs. If so,
screw one or both of the plugs onto the threaded bolt at the back of the unit before pushing the
unit into the mounting sleeve.
Place the car radio in the front of the mounting bracket and push it in until the side springs snap
into position on the left and the right (you will hear an audible click).
Removing the car radio
Insert the handles into the holes in the panel on the left and right of the radio and push them in
until you hear a distinct click (unlocks side springs).
Pull the unit out using both handles, see Fig. 3.
Note: Handles which have snapped into place can only be removed after you have pulled
the radio out of the compartment.
If you have any questions, please consult your Blaupunkt dealer or in the
United States call l-800-266-2528.
5