Filter
Top Products
SPEAKER CONNECTION INSTRUCTIONS
The unit’s Dual-Level Fader allows you to fade between the front and the rear channels using either
the front and/or rear speaker leads and/or the rear preamp outputs, providing you tremendous
flexibility in configuring your speaker arrangement:
l You can connect a speaker (regular, co-axial or tri-axial speakers or component speaker system,
all hereafter referred to simply as “speaker”) to each of the units’ four pairs of speaker leads.
l With the purchase of Blaupunkt accessory wire harness 8 643 494 218, you can connect the
4 RCA preamp outputs to multiple external amplifiers and power multiple speakers or speaker
systems through the amplifiers. (See below)
l You can use a either or both of these two methods.
l Blaupunkt amplifiers and speakers sold separately.
Connecting the Speaker Leads
To prevent short circuits or serious damage to the unit and/or speakers:
l Connect the speaker leads only as indicated in the wiring diagram. Disconnect the vehicle
battery’s negative terminal before making connections.
l Only use speakers that have impedance ratings of 4 ohms or higher and have power-handling
capabilities greater than the receiver’s stated power level.
l The unit’s internal amplifier is designed to handle a 4-ohm load on each pair of speaker leads.
l DON’T connect two soeakers to a
sit-role
oair of speaker leads (“in parallel”) unless both speakers
each have at least 8 ohms impedance.
l DON’T connect the left and riqht speaker leads to each other or to the same speakers.
l DON’T connect the front and year speaker leads to each other or to the same speakers.
l DON’T connect the negative speaker leads to each other.
l DON’T connect the positive speaker leads to each other.
l DON’T connect any active speakers (with built-in amplifiers) to the speaker leads unless their
owner’s manuals specifically state that this is O.K.
l Cover the ends of any unused leads with electrical tape. This will prevent them from touching the
vehicle or each other and causing a short-circuit and damage to the receiver or vehicle.
PREAMP OUTPUT CONNECTION
Blaupunkt wire harness 8 634 494 218
frts
In
the top block on the rear of the unit. It
rncludes
4-channel
oreamo out connections, amolifrer switch-on lead (blue/white), and cellular telephone mute (dark
green): If you purchase a Blaubunkt CDC-A05 or CDC-A071 CD Changer, you don’t need this harness
because all of these connections are included in changer’s wire harness.
AUXILIARY INPUT
If a changer IS not connected, you can connect portable audro equipment to your unit by purchasing
Blaupunkt accessory harness 7 607 890 093. This harness fits in the top block on the rear of the unit.
It includes a 2 meter aux-in cable with a 3.5 mm male plug for direct insert into your portable equipment,
as well as 4-channel preamp out connections, amplifier switch-on lead (blue), and cellular telephone
mute (purple).
ItdELESS
REMOTE CONTROLS
This receiver’s most-frequently used features can be controlled by Blaupunkt’s unique Thummer II
Steerina-Wheel Remote Control. Included with remote control are a receiving “eye” that can be placed
vrrtuallyanywhere
on the dash, as well as a wiring harness, which can be used simultaneously with the
harnesses for the preamp outout and for the changer or aux Input.
4