Filter
Top Products
Electrical Connections and Installation
G+!
!&-#GL
To avoid thg aggravation of costly mistakes and serious damage that could make
you feel this way, please carefully read all of the instructions before you begin. Carefully follow
all instructions. You’ll be glad you did!
GENERAL RECOMMENDATIONS AND NOTES
l If you’re not confident that you can install the unit correctly, have it installed by a qualified
Blaupunkt installation technician.
l Use this unit only with negative ground 12 Volt (11-16 Volt) direct current (DC).
l We recommend making and testing all electrical connections before installing the unit. Connect
the leads (wires) according to instructions and diagram below.
l This unit is protected by a quick-acting
10A
fuse. Do not substitute with any other type of fuse.
IF YOU ARE INSTALLING A COMPATIBLE BLAUPUNKT CD CHANGER
l Blaupunkt CDC-A05 and CDC-A071 changers sold separately.
l For speaker connection, use the speaker wire harness section that comes with the receiver.
l For other connections, use the wire harness sections that come with the CD Changer, not the
receiver.
l In place of this units yellow and green lead, use the changer’s blue lead for the antenna motor.
l The changer harness also includes 4-channel RCA preamp output connections, amplifier
switch-on lead and a telephone mute lead.
ELECTRICAL CONNECTION INSTRUCTIONS
1.
Disconnect the vehicle battery’s negative terminal before making connections.
2.
Connect the speakers and/or external amplifiers (if you have any) following the guidelines in
the SPEAKER CONNECTION section below.
3.
Connect the yellow and green “POWER ANTENNA+” (trigger output) lead to an antenna
motor trigger input terminal (if you have one). (Maximum amperage required must not
exceed 150mA.)
yellow/green /antenna motor
+12v
I
4.
%onnect the orange “ILLUMINATION” lead to the vehicle’s adjustable illumination (dimmer).
orange
I
illumination
2