Filter
Top Products
Inputs
Usually these settings may be left set to the factory defaults. However, your receiver allows ‘fine tuning’ how your
receiver operates after the selection of an input source. Make sure you are in the SETUP MENUS and your
remote is in B&K mode.
MAIN MENU
1 Zone 1 Operation
2 Zone 2 Operation
3 Zone 1 Favorite Presets
4 Zone 2 Favorite Presets
5 System Setup
6 Memory Backup/Restore
next item SEL select
MENU exit menu system
5 System Setup
SETUP SYSTEM
1 Speakers
2 Displays
3 Inputs
4 Presets
5 Equalization
next item SEL select
MENU main menu
3 Inputs
activate SETUP INPUTS
↵ (ENTER)
SEL or ENTER2
move to Inputs
∧ (UP) or ∨ (DOWN)
(PAUSE) or (STOP)
1
ActionFrom Front PanelFrom Remote
Select input -
SETUP DVD INPUT
1 Favorite Mode Surround
2 Favorite Speakers 7
3 Level 0.0 dB
4 Name DVD
5 Component Video 2
6 DVD Audio Input No
next item adjust
MENU setup system
SETUP DVD INPUT
select sourceVOLUME KNOB
(REW) or
(FF)
1
ActionFrom Front PanelFrom Remote
Set the favorite audio listening mode -
Your receiver provides for 5 audio listening modes Mono, Stereo,
Surround, THX and DVD Audio (See AUDIO MODES). You may set a default audio mode and speaker selection
(excluding selection 0 ‘Headphone’, or selection 9 ‘LtRt’) for each of your input sources. When a source is
selected from the remote control or front panel, the audio mode will automatically be set to use this favorite mode
and speaker selection. Note that DVDA mode can only be selected if that input is designated as the DVD audio
input below.
39
p/n 12858 Rev. 0717A