B&K AVR307 Stereo Receiver User Manual


 
SETUP DISPLAYS
1 Front Panel Bright
2 Overlay Opaque Bright
3 Backround Color Blue
4 Z1 Monitor Video Manual
5 Z1 Monitor Aspect 4 : 3
next item adjust
MENU setup system
2 Overlay Opaque Bright
change overlay typeVOLUME KNOB
(REW) or

(FF)
2
move to Overlay
(UP) or (DOWN)
(PAUSE) or (STOP)
1
ActionFrom Front PanelFrom Remote
Set the background color for your on-screen display menus -
SETUP DISPLAYS
1 Front Panel Bright
2 Overlay Opaque Bright
3 Backround Color Blue
4 Z1 Monitor Video Manual
5 Z1 Monitor Aspect 4 : 3
next item adjust
MENU setup system
3 Backround Color Grey
change background colorVOLUME KNOB
(REW) or

(FF)
2
move to Background Color
(UP) or (DOWN)
(PAUSE) or (STOP)
1
ActionFrom Front PanelFrom Remote
Set your Zone 1 (A) monitor video operation -
More than likely you have a composite or S-VIDEO monitor
which will be used to view your selected source’s video. Your receiver has the capability to process BOTH
composite video and S-VIDEO simultaneously. Your receiver DOES NOT convert between composite video and
S-VIDEO.
In MANUAL mode your receiver will always send both composite video and S-VIDEO to your Zone 1 (A) monitor.
When your receiver first detects video on a selected source it checks to see if it is composite or S-VIDEO or both.
It then shows a message which displays the current status as to the incoming video ‘Composite’, ‘S-VIDEO’ or
‘Both Video’, to both video outputs. When no video is available on one of the video formats (composite or
S-VIDEO), it will send its internal background screen to the monitor and then prompt you if there is video available
using the other video format.
In AUTO mode, your receiver will look for S-VIDEO on the selected source. If it finds S-VIDEO it will send it to your
Zone 1 (A) monitor. Your receiver will also look for composite video on the selected source. If it finds composite
video it will send it to your Zone 1 (A) monitor. If it finds no S-VIDEO on the selected source it will send no video.
Similarly if it finds no composite video on the selected source it will send no video. This allows for the use of your
Monitor’s auto video detection circuit (if available) to select the proper video format for your viewing.
37
p/n 12858 Rev. 0717A