Beyerdynamic 470.368 Headphones User Manual


 
Headzone Hardware
- 11 -
5.2 DT 770 PRO HT / DT 880 PRO HT Headphones
In addition to conventional headphones, the DT 770 PRO HT or DT 880 PRO HT is equipped with a head tracker exciter rail
containing the ultrasonic transmitters.
The head tracker exciter rail has a small integrated button on the rear that resets the head tracker when defining a new “front”
position. To reset, press the reset button for about two seconds. During this time, do not move your head. Also make sure not to
obscure the ultrasonic transmitters with your arm or hand.
The reset button on the exciter rail is interactive with the “Reset” button in the Headzone control panel. The control panel also
provides additional information regarding the current position of the head tracker and the “front” position (refer to chapter
8.5.7 “Viewing and customising the Headtracker” for details).
The DT 770 PRO HT or DT 880 PRO HT provides a gold-plated mini stereo jack plug (3.5 mm) with a 1/4" adapter (6.35 mm) and can
also be used as normal stereo headphones.
5.3 Headzone rail and clip
The “Headzone Rail” represents the counterpart to the exciter rail of
the DT 770 PRO HT or DT 880 PRO HT, i.e. it contains the ultrasonic
receivers for the head tracker.
The Headzone rail comes with a 3/8" thread to be mounted on any
standard microphone stand.
The aluminium hinge can be removed from the plastic rail for easier
transportation. Just slide the rail from the aluminium part.
The “Headzone Clip” allows versatile positioning of the Headzone
rail, e.g. placing on flat surfaces, TFT screens or wall-mounting. Use a
coin or similar object to attach the Headzone clip to the Headzone
rail with the provided screw.
It is also possible to feed the connecting cable of the Headzone rail
through the opening in the Headzone clip (separate the Headzone
clip into its two plastic parts by removing the knurled screw, feed
through the cable and reassemble the parts in reverse order). This is
especially suitable for mounting the Headzone rail on a wall.
Reset Button
for mounting onto
TFT screens
for placing on flat
surfaces or tube screens
Front View Back View
for wall mounting