Filter
Top Products
12
Emerge EMS Installer/User Guide
Chapter 2: Installation
13
2. Insert the IEC connector of the supplied power
cord into the corresponding socket of the
power supply.
3. When all other connections have
been made at the transmitter and
receiver units, connect the other end
of the power cord to a nearby
earthed mains socket.
To Connect the Power Adaptor
NOTE: Please read and adhere to the electrical safety information given within the Safety
Precautions section of this guide. In particular, do not use a 2-wire (unearthed) extension cord.
1. Locate the supplied power adaptor and attach
its output connector to the socket
labeled PWR on the Emerge EMS
transmitter.
Figure 2.9: Connecting the power
adaptor to the transmitter unit
Figure 2.10: Connecting the power adaptor to the power cord