Filter
Top Products
8
Emerge EMS Installer/User Guide
Chapter 2: Installation
9
Making Standard Connections
Connections to the Emerge units do not need to follow the precise order given in this user guide
although it is recommended that you do not apply power to the units until all other connections
have been made.
Note: Unless stated otherwise, all connection information given here applies to both the Emerge
EMS1000P and EMS1000MP series products.
Connections at the Transmitter
To Connect Video and Audio from the Source PC System
1. Attach a video cable of suitable type and length (fully shielded with 15 way
male D-type connectors at both ends – 6 feet or less) to the socket
labeled RGBHV IN on the Emerge EMS transmitter.
2. Attach the other end of the video cable to the appropriate
VGA video output socket on the source PC system.
3. Attach a stereo audio cable (shielded with three
way 3.5mm jack plugs at both ends) to the
socket labeled on the Emerge EMS
transmitter.
4. Attach the other end of the stereo
audio cable to the appropriate
audio output socket on
the source PC system.
Figure 2.4: Connecting video and audio signals from the source PC system