Filter
Top Products
6
Emerge EMS Installer/User Guide
Chapter 2: Installation
7
0.19" (5mm
)
0.37" (9.5mm)
Mounting
Before you begin connecting to the source PC system and display units, it is advisable to mount
the Emerge EMS units in place. There are a number of mounting possibilities for the transmitter
and receiver units:
• On a horizontal surface using the supplied self adhesive feet,
• Mounted on a screw using the rear slot,
• Within the optional rack mount chassis,
• On inclined surfaces using self adhesive Velcro
©
strips (not supplied).
Using the supplied self adhesive feet
Apply the supplied self-adhesive rubber feet
to the underside corners of the Emerge EMS
units.
Using the rear mounting slot
The slot at the rear of each unit allows
it to be hung upon a xed screw that
protrudes from the mounting surface.
IMPORTANT: The internal circuit board
is accessible through the mounting
slot. Ensure that the mounting screw
protrudes no further than ” (12.5mm)
into the unit casing - serious electrical
damage will be caused if the screw
makes contact with the internal circuitry.
Figure 2.1: Applying the self adhesive rubber feet
Figure 2.2: The rear mounting slot