Filter
Top Products
q
ON/OFF — Turns the selected marker on or off.
q
EDIT — Opens the selected marker parameter for data entry. Press
ENTER when data entry is complete or ESCAPE to restore the previous
value.
q
PEAK BETWEEN M3 & M4 — Places the selected marker at the peak be
-
tween marker M3 and marker M4.
q
VALLEY BETWEEN M3 & M4 — Places the selected marker at the valley
between marker M3 and marker M4.
q
BACK — Returns to the Main Markers Menu.
LIMIT
Pressing LIMIT on the data keypad activates a menu of limit related functions.
Use the corresponding softkey to select the desired limit function. Then use the
Up/Down arrow key to change its value, which is displayed in the message area
at the bottom of the display.
Choosing
LIMIT in FREQ or DTF measurement modes causes the soft keys be
-
low to be displayed.
q
SINGLE LIMIT — Sets a single limit value in dBm. Menu choices are:
ON/OFF
EDIT
BACK
q
MULTIPLE LIMITS — Sets multiple user defined limits, and can be used to
create a limit mask for quick pass/fail measurements. Menu choices are:
SEGMENT 1
SEGMENT 2
SEGMENT 3
SEGMENT 4
SEGMENT 5
BACK
q
LIMIT BEEP — Turns the audible limit beep indicator on or off.
Choosing
LIMIT in SPECTRUM ANALYZER measurement mode causes the soft
keys below to be displayed.
q
SINGLE LIMIT — Sets a single limit value in dBm. Menu choices are:
ON/OFF
EDIT
BACK
q
MULTIPLE UPPER LIMITS — Sets multiple user defined upper limits, and
can be used to create an upper limit mask for quick pass/fail measurements.
Menu choices are:
SEGMENT 1
SEGMENT 2
SEGMENT 3
SEGMENT 4
SEGMENT 5
BACK
q
MULTIPLE LOWER LIMITS — Set multiple user defined lower limits, and
can be used to create a lower limit mask for quick pass/fail measurements.
Menu choices are:
2-17
Chapter 2 Functions and Operations