Alpine CDA-7998 CD Player User Manual


 
5-EN
Basic Operation
Opening the Front Panel
1 Press the Open button on the Front Panel.
NOTE
The display will close a half minute after the ignition key is
turned to the OFF position.
Hiding the Front Panel
1 Press and hold the c button on the Front Panel for at
least 3 seconds.
NOTES
The Front Panel will stop moving if there is an obstacle inside
the compartment. In that case, remove the obstacle and press
and hold the c button again for at least 3 seconds.
The display will close shortly after the ignition key is turned to the
OFF position.
Initial System Start-Up
Be sure to press the RESET switch when using the unit
for the first time, after installing the CD changer, etc., or
after changing the car battery.
1 Make sure that the power of the unit is off. If the power
is on, press and hold the POWER button for at least 3
seconds to turn off the unit.
2 Press the RESET switch with a ball-point pen, or any
other pointed object.
Turning Power On and Off
1 Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except the
eject c button, Rotary encoder and CLK button (CDA-7897 only).
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off. Press and hold the POWER button for at least 3
seconds to turn off the unit.
NOTE
The first time power is turned on, the volume will start from level
12.
Display Angle Adjustment
The movable display may be adjusted to 3 different
angles depending upon user preference.
1 Press the ANGLE 89 button to adjust the angle of the
movable display.
NOTES
The display will close a half minute after the ignition key is
turned to the OFF position.
The adjusted angle of the display is stored in memory. There
is no need to re-adjust the angle when the power is turned
back on.
CAUTION
Keep hands (or any other object) away from the display while it
is opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Open Button
POWER RESET
ANGLE 89
c
RESET
Movable display