Filter
Top Products
8
ENGLISH
SELECTING EXTERNAL AUDIO/VIDEO
SOURCES
To play equipment connected to the unit, proceed as follows.
1
Press VIDEO1/2/3 or AUX/PHONO/5.1CH
repeatedly to select a desired source.
The source names are displayed cyclically as below.
When VIDEO1/2/3 is pressed
When AUX/PHONO/5.1CH is pressed
Select one of the sources depending on the equipment
connected to the input terminals on the unit.
∗
While the headphones are plugged in, 5.1chIN is not displayed.
2
Play the connected equipment.
To monitor a video source
The selected video source is indicated on the display and the
video signal through MONITOR/VIDEO OUT jack is output on
the TV.
To adjust the sound level of equipments connected to
the input jacks (except a equipment connected to PHONO
jacks)
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as follows.
1 Press VIDEO1/2/3 or AUX/PHONO/5.1CH repeatedly so that
the name of the jacks connected with the concerned
equipment is displayed.
Example: To adjust the sound level of equipment connectedto
VIDEO 1, press VIDEO1/2/3 repeatedly to display VIDEO1.
2 Play the equipment.
3 Press f or g until the sound level becomes the same
as that of other function sources.
NOTE
• During recording, the sound level can not be adjusted.
• The sound level of the connected turntable cannot be adjusted.
CONNECTING A DVD PLAYER
5.1CH INPUT jacks of this unit support the DOLBY DIGITAL
SURROUND system (see page 25).
Connect a DVD player with 5.1ch output jacks to this unit using
cables with RCA phono plugs as follows:
This unit’s jack DVD player’s jack
5.1CH INPUT FRONT (L, R) 5.1CH OUTPUT FRONT (L, R), etc.
5.1CH INPUT SURROUND (L, R) 5.1CH OUTPUT SURROUND (L, R), etc.
5.1CH INPUT CENTER 5.1CH OUTPUT CENTER, etc.
5.1CH INPUT SUB WOOFER 5.1CH OUTPUT SUB WOOFER, etc.
VIDEO/AUX IN (L, R) LINE OUT (L, R), etc.
(See NOTE .)
NOTE
• If the DVD player is not connected to AUX IN jacks:
- the spectrum analyzer does not show the sound level of the
DVD player.
- the sound from the connected DVD player cannot be recorded.
To remove these limitations, connect LINE OUT jacks of the
DVD player to AUX IN jacks of this unit besides connecting to
5.1CH INPUT jacks.
The signals through AUX IN jacks enable the spectrum analyzer
to work and the recording to be done.
Refer also to the operating instructions of the DVD player.
• The DOLBY DIGITAL SURROUND sound cannot be recorded
in any way.
NOTE
VIDEO 1/2/3
AUX/PHONO/5.1CH
f,g
VIDEO1 VIDEO2 VIDEO3
AUX 5.1chIN
∗
PHONO