Filter
Top Products
To play equipment connected to VIDEO/AUX/PHONO IN jacks
proceed as follows.
1 Press VIDEO/AUX/PHONO.
“VIDEO” appears on the display.
2 Play the connected equipment.
To change a source name rm the display
When VIDEO/AUX/PHONO is pressed, “VIDEO” is displayed
initially. It can be changed to “AuX,” “TV” or “PHONO?
With the power on, press POWER while pressing VIDEO/AUX/
PHQNQ,
Repeat the procedure to select one of the names.
Occasional care and maintenance of the unit and the :software
are needed to optimize the performance of your unit.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution.
DO not US13strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
To clean the tape heads
When the tape heads are dirty;
- high frequency sound is not emitted
- the sound is not adequately high
- the sound is off-balance
- the tape cannot be erased
- the tape cannot be recorded on
After every 10 hours of use, clean the tape heads with a head
cleaning cassette.
Refer to the instructions of the cleaning cassette for details.
To demagnetize the tape heads
The tape heads may become magnetized after long-term
IJW.
This may narrow the output range of recorded tapes and increase
noise.
After every 20 to 30 hours of use, demagnetize the tape hsads
with a separately sold demagnetizing cassette.
Ffefer to the instructions of the demagnetizing cassette f(lr details.
Care of discs
● When a disc becomes dirty, wipe the disc from the center out
with a cleaning cloth.
@
,,,,,
,,
,’
- ,,
‘, .,,
cAfter playing a disc, store the disc in its case. Do not Ieav(?the
disc in places that are hot or humid.
Care of
tapes
● Store tapes in their cases after use.
. Do not leave tapes near magnets, motors, television sets, or
any source of magnetism. This will downgrade the sound quality
and cause noise.
● Do not expose tapes to direct sunlight, or leave therm in a car
parked in direct sunlight,