Filter
Top Products
RADIO RECEPTION
K==3
1
2
PressTUNER/BAND to select the FM or AM band.
When TUNER/BAND is pressed while the power is off, the
power is turned on directly (Direct Play Function).
To select a band with the remote control
Press BAND while pressing SHIFT.
Press 4 DOWN or -UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, [{[~)1) is displayed.
[[mm])
To search for a station quickly (Auto Search)
Keep 44 DOWN or -UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press * DOWN or *UP.
● The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control while pressing SHIFT
so that “MONO” appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, press MONO TUNER on the remote
control while pressing SHIFT so that “STEREO” appears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing - on the unit.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
■
“
CLEAR ~ “.
F
-d
.
PRESET
The unit can store a total of 32 preset stations. When a station is
stored, a preset number is assigned to the station. Use the preset
number to tune in to a preset station directly.
1
2
3
Press TUNER/BAND to select a band, and press
a DOWN or -UP to select a station.
Press 1I SET to store the station.
A preset number beginning from 1 in consecutive order lor
each band is assigned to the station.
Preset number
I
Repeat steps 1 and 2.
No more stations will be stored if a total of 32 preset :staticms
have already been stored.
m
“FULL” is displayed if you attempt to store more than 32 pKXW
stations.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly,
7 Press BAND while pressing SHIFT to sedeclt a
band.
2 Press numbered buttons O-9 and +1O to select a
preset number.
Example:
To select preset number 20, press +10, +10 and O.
To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND to select a band. Then, press -P’RESET
repeatedly.
Each time -PRESET is pressed, the next ascending number is
selected.
To clear a preset station
Select the preset number of the station to be cleared with the
numbered buttons. Then, press
■CLEAR, and press II SET
within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are decreased by one.
iWGILISH9